Variable Laminates Limitations Discussion
Although there are no limitations to the length of the paper required for the case study assignments, in general the paper should be at least two pages with double spacing. There needs to be at least 3 different sources that are not websites. Please be sure to follow all APA requirements
Case Study 7.1: The Case of the variable Laminates
2006 Victor E. Sower, Ph.D., C.Q.E.
A plywood manufacturer has asked for your assistance in solving a problem in the log-peeling operation. The peeling process consists of soaking debarked logs in a hot bath, fixing the logs in chucks, and rapidly spinning them while shaving off a continuous thin section called a lamination with a sharp knife blade. The laminations are then cut into sheets to be laid up, glued, and pressed into plywood sheets. The manufacturer is having difficulty maintaining a controlled thickness when peeling laminations from a log.
Discussions with engineering and the process operators indicate that four variables are related to laminate thickness: soak time, soak temperature, knife pressure, and knife setting. The knife setting is straight forward and is not felt to be a source of variation in the process. Specifications call for logs to be soaked for 60 minutes, but no process control for this process is in place. Some logs are peeled after as little as 30 minutes soak time.
The operators believe that this cause some of the variation, but they are under the gun to keep the peeler busy, even if it means compromising on the soak time. The engineers feel that knife pressure may contribute to the thickness variation. Knife pressure setting is not standardized operators set it between 250 psi and 300 psi based on their experience. Soak temperature varies between 150 degrees and 200 degrees, depending upon how much bark has accumulated around the heating coils.
Thickness measurements are made every 15 minutes on the laminate. The variation does not seem to follow a particular pattern.
Design an experiment that will assist the process engineers in determining what actions to take to reduce laminate thickness variation. Provide them with your assessment of the causes of the variation and how to use the results of the experiment to define the optimal operating conditions for the process.
Complete a response to Case Study 7.1: The Case of the Variable Laminates in your textbook. In your case analysis, be certain to answer the following questions:
- Design an experiment that will assist the process engineers use in determining what action to take to reduce laminate thickness variation. Include an assessment of the variables that may be the cause of sub-optimized output.
- How would you evaluate the organization on the concept of “repeatable work? What recommendations would you have to standardize the manufacturing process? Why is repeatable work so important in continuous improvement activities?